HIKVISION DS-K3G411 Series - Page 18

Figure 3-2 Dimension
1. Prepare for the installaon tools, check the components, and prepare for the installaon base.
2. Drill holes on the ground according to the
installaon holes on the pedestals and insert the
expansion sleeves.
3. Seal the
boom of the turnsle to avoid water from entering.
Note
Make sure the installaon holes on the pedestals and the base are aligned with each other.
4. Secure the pedestals with expansion bolts.
Note
• Do not immerse the pedestal in the water. In special circumstances, the immersed height
should be no more than 690 mm.
• The installaon footprint is as follows:
DS-K3G411 Series Tripod Turnsle Quick Start Guide
7