HIKVISION DS-KB8113-IME1(B) Series User Manual

Chapter 5 Remote Conguraon via Indoor Staon
5.1 Set Up Door Staon via Indoor Staon
Steps
1.
Choose Language and tap Next.
2.
Set network parameters and tap Next
-
Edit Local IP, Subnet Mask and Gateway parameters.
-
Enable DHCP, the device will get network parameters
automacally.
3.
Congure the indoor staon.
1) Choose Indoor Staon Type.
2) Edit Floor and Room No.
3) Tap Next.
4.
Linked related devices and tap Next. If the device and the indoor
staon are in the same LAN,
the device will be displayed in the list. Tap the device or enter the serial No. to link.
1) Tap the door
staon in the list to link.
Note
If the door staon is inacve, the system will pop up the dialog to acvate the door staon.
2) Tap to pop up the Network Sengs page.
3) Edit the network parameters of the door
staon manually or enable DHCP to get the network
parameters automacally.
4) Oponal: Enable Synchronize Language to synchronize the language of door staon with
indoor
staon.
5) Tap OK to save the sengs.
5.
Tap Finish to save the sengs.
5.2 Local
Operaon
You can call the resident (the indoor staon) or the center (the master staon) via the door staon
by pressing or holding the call buon. Default sengs of the call buon: when you press the call
buon, it calls the resident, and when you hold the call buon, it calls the center.
Before You Start
●
Make sure the door staon has been acvated.
●
Make sure the network cable is well-connected.
Steps
1.
Press the call buon to call the resident.
2.
The resident can accept/decline the calling from the door
staon, and unlock the door via the
indoor staon.
DS-KB8113-IME1(B) Series Vandal-Resistant Door Staon User Manual
15

HIKVISION DS-KB8113-IME1(B) Series Specifications

General

Brand	HIKVISION
Model	DS-KB8113-IME1(B) Series
Category	Intercom System
Language	English