HIKVISION DS-KD3003-E6 - Page 63

2.
Select the door and edit the door name.
3.
Set door contact status.
4.
Set lock acon me.
5.
Click Save to enable the
sengs.
Card Security
Click Access Control → Card Security to enter the sengs page.
Slide to enable card encrypon parameters. Click Save to enable the sengs.
Elevator Control
Before You Start
•
Make sure your door staon is in the mode of main door staon. Only the main
door staon support elevator control funcon.
•
Make sure your door staon has been connected to the elevator controller via
RS-485 wire if you want to use RS-485 interface.
Steps
1.
Click Access Control → Elevator Control to enter the corresponding
conguraon page.
Video Intercom D Series Door
Staon User Manual
50