HIKVISION DS-KH6320-LE1

Steps
1.
Choose Language and tap Next.
2.
Set network parameters and tap Next
-
Edit IP Address, Subnet Mask and Gateway.
-
Enable DHCP, the device will get network parameters
automacally.
Figure 2-3 Network Parameters
3.
Select the device type.
-
Select Indoor
Staon, and set the oor and room No. Tap Next, and set the
linked main door staon.
Note
If the main door staon and the indoor staon are in the same LAN, the
main door staon will be displayed in the list. Tap the device or enter the
serial No. to link.
Network Indoor Staon Conguraon Guide
3