Steps
Note
The default IP address of the indoor staon is 192.0.0.64.
Two ways are available for you to set IP address: DHCP, and set IP address manually.
1.
Tap Sengs → → to enter the network sengs page.
Note
Enter acvate password as the admin password.
Figure 2-7 Network Sengs
2.
Enable DHCP, then the indoor staon can search and get an IP address
automacally.
Note
Skip the following steps if you have enabled DHCP.
3.
Set the Local IP, Subnet Mask and Gateway manually.
2.3.2 Set Linked Device IP
Linked network parameters refers to the network parameters of devices (like door
staon, doorphone, master staon, center, etc.), to which the indoor staon is
linked. Linked devices for the indoor staon refers to door staon, center, master
staon, and doorphone.
Network Indoor
Staon Conguraon Guide
6