HIKVISION DS-KH6320-LE1 Configuration Guide

Figure 2-6 Related Device
1) Set the linked device's parameters.
Note
If the device is inacve, the system will pop up the dialog to acvate the
device.
2)
Tap
to pop up the Network Sengs page.
3) Edit the network parameters of the door
staon manually or enable DHCP to
get the network parameters
automacally.
4) Tap OK to save the sengs.
5.
Tap Finish to save the sengs.
2.3
Conguraon Sengs
Conguraon sengs is required before starng using the indoor staon. It is
necessary to set the indoor
staon network, room No., linked devices, device me
display, and so on.
2.3.1 Set Indoor
Staon Network Parameters
Network connecon is mandatory for the use of the indoor staon. Set the network
parameters aer acvang the indoor staon. Only when the IP address of the
indoor staon is in the same network segment as other devices, it can work properly
in the same system.
Network Indoor
Staon Conguraon Guide
5

HIKVISION DS-KH6320-LE1 Specifications

General

Brand	HIKVISION
Model	DS-KH6320-LE1
Category	Intercom System
Language	English