HIKVISION DS-KH6320-LE1 Configuration Guide

2.
Select a zone type from the drop-down list menu.
3.
Select an alarm mode from the drop-down list menu.
4.
Set the zone status: NO or NC.
5.
Set the entering delay, and
exing delay.
6.
Select triggers.
7.
Click Save to enable zone
sengs.
Note
•
7 zone types are supported: Emergency Switch, Door Magnec Switch,
Smoke Detector, Acve IR Detector, Passive IR Detector, Combusble Gas
Detector, and DoorBell Switch.
•
3 types of alarm mode are supported: Instant Alarm, 24H Alarm, and Delay
Alarm.
•
When the zone type is set to be Instant Alarm, only under arming mode, the
indoor staon will receive alarm message when the detector is triggered.
Under disarming mode, it will not receive alarm message when the detector
is triggered.
•
When the zone type is set to be 24H Alarm, the indoor
staon will receive
alarm message when the detector is triggered no maer it is under arming
mode or disarming mode.
•
When the zone type is set to be Delay Alarm, only under arming mode, the
indoor staon will receive alarm message when the detector is triggered.
Under disarming mode, it will not receive alarm message when the detector
is triggered.
•
Aer seng enter delay me, if OK is pressed within the enter delay me
aer the alarm, the alarm event will not be uploaded to the management
center; if OK is not pressed within the enter delay me aer the alarm, the
alarm event will be uploaded to the management center.
•
The exit delay is the
me between you enable the arming mode and the
arming takes eect.
IP Camera Informaon
You can add, delete and modify cameras that can be added to the video intercom
products, with two ways of
geng stream: direct or URL. By exporng and imporng
the added device informaon, you can edit added devices parameters in batch.
Network Indoor
Staon Conguraon Guide
29

HIKVISION DS-KH6320-LE1 Specifications

General

Brand	HIKVISION
Model	DS-KH6320-LE1
Category	Intercom System
Language	English