HIKVISION DS-KIS603-P Configuration Guide

Figure 1-8 Time Synchronizaon
2.
Enable Enable NTP.
3.
Set the synchronizing interval, enter the IP address/domain of NTP server and
port No., and select the me zone.
Note
•
The default unit of synchronizing interval is minute.
•
The me zone can be congured as well if the NTP is not enabled.
1.5 Sound Sengs
Set the ringtone sound and the volume.
1.5.1 Call
Sengs
You can set the ringtone, ring duraon, call forwarding me on call sengs page.
Steps
1.
Tap Sengs → to enter the call sengs page.
Network Indoor
Staon Conguraon Guide
10

HIKVISION DS-KIS603-P Specifications

General

Model	DS-KIS603-P
Category	Intercom System
Resolution	1024 x 600
Camera	2 MP HD Camera
Audio Input	Built-in Omnidirectional Microphone
Audio Output	Built-in Loudspeaker
Operating Temperature	-10°C to 55°C (14°F to 131°F)
Supported Protocols	TCP/IP, SIP, RTSP
Display	7-inch TFT LCD
Network Protocol	TCP/IP
Power Supply	12 VDC
Installation	Surface Mount
IR Supplement	IR Supplement
Protection Level	IP65
Power Consumption	<10 W
Humidity	10% - 90% (non-condensing)
Communication Interface	Ethernet