HIKVISION DS-KIS603-P Configuration Guide

me duraon. Within the congured me, this device will not be
disturbed.
Note
Indoor extension does not support the ring duraon sengs, call forwarding
sengs, or auto-answer funcon.
1.5.2 Volume Sengs
Set the microphone volume, prompt sound volume, call volume, and enable touch
sound.
Steps
1.
Tap
Sengs → → Volume Sengs to enter the volume sengs page.
2.
Set the microphone volume, prompt sound volume, and the call volume. You can
also enable Touch Sound to turn on the key sound.
1.6 Link to the Mobile Client
Steps
1.
Tap Sengs → → Hik-Connect Service Sengs to enter the sengs page.
2.
Enable Enable Hik-Connect Service.
3.
Edit LBS server and Vericaon Code.
Note
Vericaon code is used to add the device to mobile client.
4.
Oponal: Scan QR code on the screen to add the device to the mobile client.
1.7 Restore Indoor
Staon
Steps
1.
Tap Sengs → → Conguraon , and enter admin (acvaon) password.
2.
Tap to enter the system maintenance page.
3.
Tap Restore Default Sengs to restore the default sengs and reboot the
system.
Network Indoor
Staon Conguraon Guide
12

HIKVISION DS-KIS603-P Specifications

General

Model	DS-KIS603-P
Category	Intercom System
Resolution	1024 x 600
Camera	2 MP HD Camera
Audio Input	Built-in Omnidirectional Microphone
Audio Output	Built-in Loudspeaker
Operating Temperature	-10°C to 55°C (14°F to 131°F)
Supported Protocols	TCP/IP, SIP, RTSP
Display	7-inch TFT LCD
Network Protocol	TCP/IP
Power Supply	12 VDC
Installation	Surface Mount
IR Supplement	IR Supplement
Protection Level	IP65
Power Consumption	<10 W
Humidity	10% - 90% (non-condensing)
Communication Interface	Ethernet