Video Intercom Master Station·Quick Start Guide
4
2 Local Operation
2.1 Activating Device
Connect the power cable to power on the master station.
You must create a password to activate the master station for your first time usage and
when it is not activated.
Only after activating the device, you can operate the device both locally and remotely.
The password created for the activation is only used when you add the station to the
remote control software such as iVMS-4200.
To remotely access to the device, use the password here registered to add the device
to the remote client.
Figure 2-1 Activation Interface
STRONG PASSWORD RECOMMENDED– We highly recommend you to create a
strong password of your own choosing (using a minimum of 8
characters, including at least three kinds of following categories:
upper case letters, lower case letters, numbers, and special characters)
in order to increase the security of your product. And we recommend
you reset your password regularly, especially in the high security system,
resetting the password monthly or weekly can better protect your product.
To Next Page
Loading...
