HIKVISION DS-MCW407 - Connect to Guarding Vision

Steps
1.
Select Set → Network → ISUP .
2.
Enable ISUP Connecon.
Note
Aer enabling plaorm connecon, reboot the device to take the new sengs into eect.
3.
Select ISUP to set IP, Port, and other parameters.
Note
The device ID should be the same as the ID set on the plaorm.
4.
Oponal: You can do the below operaons.
Enable Force Sub-
Stream
Enable Force Sub-Stream to force the plaorm only to transmit via the
sub-stream.
View the plaorm
informaon
Select ISUP Informaon to view the informaon.
Set cloud storage If the cloud storage is set via the plaorm, you can upload the les to
cloud storage.
a. Select Cloud Storage.
b. Select Uploaded File Type.
-
Select Alarm Files to upload the alarm les to the cloud storage
server.
-
Select All Files to upload all les to the cloud storage server.
c. Select Cloud Storage Informaon to view the IP address and port
informaon of the cloud storage server.
6.4.2 Connect to Guarding Vision
The device can be remotely accessed via Guarding Vision.
Before You Start
●
Connect the device to network.
●
Set Guarding Vision parameters via Body Camera Assistant. Refer to the user manual of Body
Camera Assistant for details.
Steps
1.
Select Set → Network → Guarding Vision .
2.
Set Guarding Vision parameters.
1) Select
Sengs.
2) Enter the admin password, and select OK.
Body Camera User Manual
21