HIKVISION DS-MCW407 - Switch USB Mode; Set Read-Only USB Mode; Set Quick Charging Mode; Set Power Saving Mode

7.6 Switch USB Mode
You can switch the device to USB mode to import or export data.
Steps
1.
Select Set → System → Auto USB Mode .
2.
Enable Auto USB Mode.
3.
Enter the admin password.
What to do next
Connect the device to the computer via a data cable, and you can import or export data.
7.7 Set Read-Only USB Mode
Aer switching to the USB mode, you can set the video, audio, and picture les to be copied to the
computer only, but cannot be deleted locally.
Steps
1.
Select Set → System → Read-only USB Mode .
2.
Enable or disable the
funcon.
-
Enable the read-only USB mode, and aer switching to the USB mode, the video, audio, and
picture les can only be copied to the computer, but cannot be deleted locally.
-
Disable the read-only USB mode, and aer switching to USB mode, the video, audio, and
picture les can both be copied or cut.
7.8 Set Quick Charging Mode
You can enable or disable quick charging mode.
Steps
1.
Select Set → System → Power Supply .
2.
Enable or disable Quick Charging Mode according to your needs.
-
Enable the quick charging mode, and all the power consuming funcons, such as network,
record,
posioning, etc., will be disabled automacally while the device is being charged. The
fully-charged duraon will be shorten.
-
Disable the quick charging mode, and the device can be operated normally while being
charged. The fully-charged duraon will be longer than the quick charging mode.
7.9 Set Power Saving Mode
When the device is in low baery or produces large heat, you can enable power saving mode to
disable Wi-Fi and dial-up
funcon and lower the screen brightness to save power.
Body Camera User Manual
25