HIKVISION DS-PHA64-LP User Manual

108
Check the web page: whether the Hik-Connect is offline.
A.1.6 Alarm Information is Not Reported to APP/4200/Alarm Center
Fault Description:
After the alarm is triggered, the app/4200/ alarm center does not receive the alarm message.
Solution:
"Message push" - "alarm and tamper-proof notice" is not enabled. You should enable "alarm and
tamper-proof notice".
A.2 Mutual Exclusion of Functions
A.2.1 Unable to Enter Enrollment Mode
Fault Description:
Click the panel function key, and prompt key invalid.
Solution:
The panel is in "Hotspot" mode. Switch the panel to "station" mode, and then try to enter the
enrollment mode again.
A.3 Zone Fault
A.3.1 Zone is Offline
Fault Description:
View status of zones which displays offline.
Solution:
Check whether the detector reports undervoltage. Replace the detector battery
A.3.2 Zone Tamper-proof/Lid-opened
Fault Description:
View status of zones which displays tamper-proof/lid-opened.
Solution:
Make tamper-proof button of the detector holden.
A.3.3 Zone Triggered/Fault
Fault Description:

HIKVISION DS-PHA64-LP Specifications

General

Wi-Fi	Yes
Wi-Fi frequency	2.4 GHz
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Number of alarm zones	64
Connectivity technology	Wired & Wireless
Operating temperature (T-T)	-10 - 40 °C
Number of simultaneous users	62 user(s)
Operating relative humidity (H-H)	10 - 90 %
Number of simultaneously connected devices (max)	-
Batteries included	No
Number of door/window sensors	- pc(s)
Mounting type	Wall
Product color	White
Housing material	Plastic
Battery life	36 h
Alarm current	2000 mA
Input voltage	100 - 240 V
Battery voltage	12 V
Battery capacity	7000 mAh

Weight and Dimensions

Alarm control panel weight	997 g
Alarm control panel dimensions (W x D x H)	261 x 86.4 x 199 mm