28
Note
● After the keypad is configured, you can click Maintenance → Device Status → Keypad Status
to view the keypad status.
● You can set the keypad password on the page of User → User Management→ Operation.
Keyfob
You can set the parameters of the keyfob.
Steps
1. Click Device → Keyfob to enter the page.
2. Click Enroll to add a keyfob.
3. Click to edit the keyfob parameters.
4. Enable the keyfob.
5. Select a linked user.
6. Configure the functions of the buttons according to your actual needs.
7. Click OK.
Tag
You can set the parameters of tags.
Steps
1. Click Device → Tag to enter the page.
2. Click Enroll, enter the serial No. to add a tag, or click to edit the tag parameters.
To Next Page
Loading...
