52
While enabled, the system will alert with buzzer for the tamper alarm.
Alarm Duration
The time duration of the panel alarm.
Wireless Supervision Loss
Set the maximum duration for polling loss. The system will report fault if the duration is over
the limit.
Bypass on Re-Arm
While enabled, the zone with fault will be bypassed automatically when re-arming.
Jamming Sensitivity Settings
The device will detect RF interference and push messages when the RF interference interferes
with communication. You can adjust the detection sensitivity.
Fault LED Stay On When Armed
When system is armed, the fault indicator is always on.
Arm LED Stay On
The arm LED is always on.
Hik-Connect Indicator
Enable the Hik-Connect indicator.
Motion Detector Restore
Motion detectors include all PIR detectors.
Power Save Mode
While enabled, the main power supply is off, Wi-Fi enters low power consumption, 4G closes,
tag reading fails, LED off, and voice prompt off.
Smoke Detector Reset
Click Reset to reset the smoke detector
Fault Check
The system determines whether to check the faults listed on the page. The system will only check
the fault that is selected.
Steps
1. On the device list page, tap the AX PRO and then log in to the device (if required) to enter the
page.
2. Tap → System → System Options → System Fault Check to enter the page.
Detect Network Camera Disconnection
If the option is enabled, when the linked network camera is disconnected, an alarm will be
triggered.
To Next Page
Loading...
Need help?
General
