HIKVISION DS-PTA-WL-868 User Manual

69
2. Select the Alarm Receiver Center as 1 or 2 for configuration, and slide the slider to enable the
selected alarm receiver center.
Note
Only if the alarm receiver center 1 is enabled, you can set the alarm receiver center 2 as the
backup channel and edit the channel parameters.
3. Select the Protocol Type as ADM-CID, ISUP, SIA-DCS, *SIA-DCS, *ADM-CID, CSV-IP, or FSK
Module to set uploading mode.

HIKVISION DS-PTA-WL-868 Specifications

General

Brand	HIKVISION
Model	DS-PTA-WL-868
Category	IP Access Controllers
Language	English