Figure 5-12 Motion Detection Settings-Expert
Steps:
(1) Set the Day&Night switch mode, there are OFF, Auto-Switch and Scheduled-Switch
selectable. If the Day&Night switch mode is enabled, you can configure the detection
rule for the day and night separately.
OFF: Disable the day and night switch.
Auto-Switch: Switch the day and night mode according to the illumination
automatically.
Scheduled-Switch: Switch to the day mode at 6:00 a.m., and switch to the night mode
at 18:00 p.m..
(2) Select Area No. to configure in the dropdown list.
(3) Set the values of sensitivity and proportion of object on area.
Sensitivity: The greater the value is, the easier the alarm will be triggered.
Proportion of Object on Area: When the size proportion of the moving object exceeds
the predefined value, the alarm will be triggered. The less the value is, the easier the
alarm will be triggered.
4. Set the Arming Schedule for Motion Detection.
(1) Click tab to enter the arming schedule setting interface.
To Next Page
Loading...
Need help?
General
