You have to set the recording schedule to realize this function. Please refer to
Section 5.1.1 Configuring Recording Schedule for settings the recording schedule.
Trigger Alarm Output
Trigger one or more external alarm outputs when an event occurs.
To trigger an alarm output when an event occurs, please refer to Section 5.2.4
Configuring Alarm Output to set the alarm output parameters.
5.2.2 Configuring Video Tampering Alarm
Purpose:
You can configure the mini PTZ camera to trigger the alarm actions when the lens is covered.
Steps:
1. Enter the Video Tampering Settings interface :
Configuration > Event > Basic Event > Video Tampering
Figure 5-17 Tampering Alarm
2. Check Enable checkbox to enable the tampering detection.
To Next Page
Loading...
