4. Click tab to enter the arming schedule setting interface. The arming
schedule configuration is the same as the setting of the arming schedule for motion detection.
Refer to Step 2 Set the Arming Schedule for Motion Detection in Section 5.2.1 Configuring
Motion Detection.
5. Click tab to select the linkage method taken for the video loss alarm,
including Notify surveillance center, send email, trigger channel, smart tracking and trigger
alarm output are selectable. Refer to Step 3 Set the Alarm Actions for Motion Detection in
Section 5.2.1 Configuring Motion Detection.
6. You can also choose the PTZ linking for the alarm input. Check the relative checkbox and
select the No. to enable Preset Calling, Patrol Calling or Pattern Calling.
7. You can copy your settings to other alarm inputs.
8. Click to save the settings.
Figure 5-19 Linkage Method
5.2.4 Configuring Alarm Output
Steps:
1. Enter the Alarm Output Settings interface:
Configuration> Event > Basic Event > Alarm Output
2. Select one alarm output channel in the Alarm Output drop-down list.
3. Set a name in for the alarm output
(optional).
4. The Delay time can be set to 5sec, 10sec, 30sec, 1min, 2min, 5min, 10min or Manual. The
delay time refers to the time duration that the alarm output remains in effect after alarm
occurs.
To Next Page
Loading...
