HIKVISION E Series - Configuring Park Actions

User Manual of E Series Network Mini PTZ camera
© Hikvision
60
1. Enter the Initial Position Configuration interface:
Configuration > PTZ > Initial Position
Figure 5-27 PTZ Configuration
2. Click the PTZ control buttons to find a position as the initial position of the mini PTZ camera;
you can also call a defined preset and set it as the initial position of the mini PTZ camera.
3. Click Set to save the position.
 Call/delete an Initial Position:
You can click to call the initial position. You can click to delete the initial position and
restore the factory default initial position.
5.4.4 Configuring Park Actions
Purpose:
This feature allows the mini PTZ camera to start a predefined park action (scan, preset, pattern
and etc.) automatically after a period of inactivity (park time).
 Scheduled Tasks function is prior to Park Action function. When these two functions are set
at the same time, only the Scheduled Tasks function takes effect.
 Pattern function varies depending on mini PTZ camera models.
Steps:
1. Enter the Park Action Settings interface:
Configuration > PTZ > Park Action