QSG EKI-K41B44W Kit 110520NA 12
c) Connect one end of power cable to HDD.
d) Connect the other end of power cable to the device motherboard.
Figure 6, Connect Cables
3.
Set the device up, match HDD screw threads with the reserved holes on the device bottom, and fix HDD
with screws.
Figure 7, Fix HDD to Device Bottom
4.
(Optional) Repeat the steps above to install other HDDs.
5.
Reinstall the device cover, and fasten screws.
3 Camera Installation
Before You Start
●
Make sure the device in the package is in good condition and all the assembly parts are included.
●
The standard power supply is 12 VDC. Make sure your power supply matches your camera.
To Next Page
Loading...
