QSG EKI-K41B44W Kit 110520NA 16
6.
Route the cables through the cable hole.
7.
Combine the junction box cover with its body with three screws on the junction box‘s cover.
Figure 14, Combine Junction Box’s Cover with its Body
8.
Repeat steps 5 of
3.1 Ceiling Mounting
to complete the installation.
3.3 Waterproof Measures
If the camera is installed outdoors, use the waterproof accessory or tape to waterproof the cables.
Otherwise, the cables might get wet or a short circuit occurs.
3.3.1
Install Network Cable Waterproof Jacket
Figure 15, Install Waterproof Jacket
1.
Feed the network cable through ① and ③ in order.
2.
Fix ② on the network cable between ① and ③.
3.
Place ⑤ onto the end of ⑥, and plug the RJ-45 male connector into RJ-45 female connector.
4.
Screw ③ to ⑥ clockwise.
5.
Push ② into ③.
6.
Secure ① with the ③ in clockwise direction.
To Next Page
Loading...
