QSG EKI-K41B44W Kit 110520NA 17
3.3.2
Waterproof Other Cables
After routing and connecting the cables, use the waterproof tape to wrap up the cables. Connected
cables and spare cables both should be wrapped as the figures below.
Figure 16, Waterproof Cables
4 Menu Operation
4.1 Startup and Shutdown
To start your NVR:
1.
Check the power supply is plugged into an electrical outlet. It is HIGHLY recommended that an
Uninterruptible Power Supply (UPS) be used in conjunction with the device. The Power button on the
front panel should be red, indicating the device is receiving power.
2.
Plug the power adapter in to supply power to the NVR, there is no on/off switch. The Power LED should
turn blue. The unit will start.
After the device starts up, the wizard will guide you through the initial settings, including modifying
password, date and time settings, network settings, HDD initializing, and recording.
To shut down the NVR:
1.
Enter the Shutdown menu. Go to Menu > Shutdown.
2.
Select Shutdown.
3.
Click Yes.
To Next Page
Loading...
Need help?
General
