HIKVISION HF-VS409

Note
Network can idenfy the priority of data transmission. The bigger the DSCP value is, the higher
the priority is. You need to set the same value in router while conguraon.
3.
Click Save.
Set IEEE 802.1X
IEEE 802.1x is a port-based network access control. It enhances the security level of the LAN/
WLAN. When devices connect to the network with IEEE 802.1x standard, the
authencaon is
needed.
Go to Conguraon → Network → Advanced Sengs → 802.1X , and enable the funcon.
Set Protocol and EAPOL Version according to router informaon.
Protocol
If you use EAP-MD5, the authencaon server must be congured. Register a user name and
password for 802.1X in the server in advance. Input the user name and password for
authencaon.
EAPOL Version
The EAPOL version must be idencal with that of the router or the switch.
Set Open Network Video Interface
If you need to access the device through Open Network Video Interface protocol, you can
congure the user sengs to enhance the network security.
Steps
1.
Go to Conguraon → Network → Advanced Sengs → Integraon Protocol .
2.
Check Enable Hikvision-CGI.
3.
Check Enable ONVIF.
4.
Click Add to
congure the Open Network Video Interface user.
Delete
Delete the selected Open Network Video Interface user.
Edit Edit the selected Open Network Video Interface user.
5.
Click Save.
6.
Oponal: Repeat the steps above to add more Open Network Video Interface users.
Set Network Service
You can control the ON/OFF status of certain protocol as desired.
HF-VS409 Smoke Detected Camera User Manual
40