HIKVISION HF-VS409

Before You Start
Note
Indoor Passage Blockage Detecon and Fire Source Detecon will be out of service when On/O
Duty Detecon is enabled.
Steps
1.
Click Conguraon → Event → Smart Event → On/O Work Detecon .
2.
Check Enable.
3.
Set detecon area and disabled area.
1) Click Draw Detecon Area/Draw Disabled Area.
2)
Le-click to draw a convex quadrilateral.
3) Repeat step a and step b to draw less than 4 detecon areas/disabled areas.
4)
Oponal: You can edit the areas you draw as follows.
●
Hover mouse inside a zone and drag to change its
locaon.
●
Hover mouse on the vertexes of an area and drag to adjust the their
locaons.
●
Click Clear All to delete all areas exist.
Device will process smart detecon and analysis on events in detecon areas and neglect
feedbacks from disabled areas.
4.
Set
detecon parameters.
Number of Alarm People Threshold
If the detected number of
sta in the detecon zone is less than the lower limit sengs, the
alarm will be triggered.
O Work Detecon Time (s)
If the number of o-work sta is under the sengs and the duraon reaches the me
sengs,
the re alarm will be triggered.
Sensivity
The more sensive the detecng funcon is, the more easily the alarm will be triggered and
the more likely to misidenfy.
5.
Set arming schedule. See Set Arming Schedule .
6.
Set linkage method. See Linkage Method Sengs .
7.
Click Save.
7.4.7 Storage
Sengs
Memory Card
You can view the capacity, free space, status, type, and property of the memory card. Encrypon of
memory card is supported to ensure data security.
HF-VS409 Smoke Detected Camera User Manual
58