HIKVISION PanoVu Series Quick Start Guide

PanoVu Series Camera·Quick Start Guide
21
Figure 3-3 SADP Interface
3. Create a password and input the password in the password field, and confirm the password.
STRONG PASSWORD RECOMMENDED–We highly recommend you create a strong
password of your own choosing (Using a minimum of 8 characters, including at least
three of the following categories: upper case letters, lower case letters, numbers, and
special characters.) in order to increase the security of your product. And we
recommend you reset your password regularly, especially in the high security system,
resetting the password monthly or weekly can better protect your product.
4. Click OK to save the password.
You can check whether the activation is completed on the popup window. If activation failed,
please make sure that the password meets the requirement and then try again.
3.3 Modifying the IP Address
Purpose:
To view and configure the panoVu camera via LAN (Local Area Network), you need to connect the
network panoVu camera in the same subnet with your PC. Then, install the SADP software or client
software to search and change the IP of network panoVu camera. We will take modifying the IP
Address via SADP software as an example to introduce the IP address modification.
Steps:
1. Run the SADP software.
2. Click to select an active device.
Please refer to the section 3.2 Activating the PanoVu camera to activate the panoVu
camera if it is inactive.

HIKVISION PanoVu Series Specifications

General

Brand	HIKVISION
Model	PanoVu Series
Category	Security Camera
Language	English