HIKVISION PanoVu Series - Set Power off Memory; Set PTZ Priority

4.14 Set Power O Memory
This funcon can resume the previous PTZ status of device aer it restarng from a power-o.
Steps
1. Go to
Conguraon → PTZ → Basic Sengs .
2. Select Resume Time Point. When the device stays at one
posion for the set resume me point
or more, the posion is saved as a momory point. The device returns to the last memory point
when it restarts.
3. Click Save.
4.15 Set PTZ Priority
The funcon can set the PTZ priority of dierent signals.
Steps
1. Go to
Conguraon → PTZ → Priorize PTZ .
2. Set the priority signal and delayed me.
Network
The network signal controls the device with priority.
RS-485
The RS-485 signal controls the device with priority.
Delay
It refers to the
me interval of PTZ operaon controlled by dierent signals. When the
operaon with high priority is nished, the low priority signal controls the device aer the
seng interval.
3. Click Save.
Stched PanoVu Camera with PTZ User Manual
30