HIKVISION PanoVu Series - Chapter 8 Event and Alarm; Basic Event

Chapter 8 Event and Alarm
This part introduces the conguraon of events. The device takes certain response to triggered
alarm.
8.1 Basic Event
8.1.1 Set Moon Detecon
This funcon detects moving objects in the detecon region and trigger linkage acons.
Steps
1. Go to
Conguraon → Event → Basic Event → Moon Detecon .
2. Select the channel No.
3. Check Enable Moon Detecon.
4. Oponal: (Only available in PTZ channel) Check Enable Moon Detecon in PTZ Control, and
the device detects moving targets in PTZ movement.
5.
Oponal: Highlight moving objects in green.
1) Check Enable Dynamic Analysis for
Moon.
2) Go to Conguraon → Local to enable Rules.
6. Select
Conguraon Mode. Normal mode and expert mode are selectable.
-
For the
informaon about normal mode, see Normal Mode .
-
For the
informaon about expert mode, see Expert Mode .
7. Set the arming schedule. See Set Arming Schedule for details.
8. Set linkage methods. See Linkage Method
Sengs for details.
9. Click Save.
Normal Mode
You can set moon detecon parameters according to the device default parameters.
Steps
1. Select normal mode in
Conguraon.
2. Set the sensivity of normal mode. The higher the value of sensivity is, the more sensive the
moon detecon is. If the sensivity is set to 0, moon detecon and dynamic analysis do not
take
eect.
3. Click Draw Area. Click and drag the mouse on the live video, then release the mouse to nsh
drawing one area.
Stched PanoVu Camera with PTZ User Manual
60