To Next PageTo Next PageWhy is there carbon build-up and thick black smoke coming from my Hiland Premium?
Carbon build-up and thick black smoke can be caused by dirt or film on the reflector and burner screen, or a blockage in the burner. To resolve this, clean the reflector and burner screen. Also, remove any blockage and clean the burner inside and outside.
What to do if the Hiland Premium Patio Heater doesn't ignite?
If your Hiland Patio Heater doesn't ignite, consider these potential issues: * The cylinder valve may be closed. Open the valve. * There could be a blockage in the orifice or pilot tube. Clean or replace the orifice or pilot tube. * There might be air in the gas line. Open the gas line and bleed it (pressing the control knob in) for no more than 1 - 2 minutes or until you smell gas. * Low gas pressure with the cylinder valve fully open. Turn the cylinder valve OFF and replace the cylinder. * Igniter failure. Use a match to light the pilot; obtain a new igniter and replace it.
How to fix a Hiland Patio Heater when the pilot won't stay lit?
If the pilot light on your Hiland Patio Heater won't stay lit, here are some possible causes and solutions: * Dirt around the pilot: Clean any dirt from around the pilot. * Loose connection: Tighten the connection between the gas valve and pilot assembly, and then perform a leak check. * Faulty thermocouple: Replace the thermocouple.
Why won't my Hiland Premium pilot light?
If the pilot light on your Hiland Patio Heater won't light, open the gas line and bleed it by pressing the control knob in for no more than 1-2 minutes, or until you smell gas. If the efficiency is reduced below 40°F, turn the cylinder valve OFF and replace the cylinder. You can also use a match to light the pilot, but consider obtaining a new igniter and replacing the old one.
What to do if my Hiland Patio Heater burner won't light?
If the burner on your Hiland Patio Heater isn't lighting, there are a few things to check. First, if the propane cylinder is frosted over, wait for it to warm up. Also, check for any blockages in the orifice and clear them. Finally, make sure the control knob is turned to the ON position.
How to fix Hiland Patio Heater pilot light that won't light?
If the pilot light on your Hiland Patio Heater won't ignite, several factors could be at play. Start by checking for blockages in the orifice or pilot tube, and clean or replace them if necessary. Air in the gas line can also prevent ignition; bleed the gas line by pressing the control knob for no more than 1-2 minutes, or until you smell gas. Low gas pressure can be another culprit; if the cylinder valve is fully open, turn it OFF and replace the cylinder. Lastly, a faulty igniter can be the issue; try lighting the pilot with a match as a temporary solution, and replace the igniter.
Why won't the burner light on my Hiland Patio Heater?
If the burner on your Hiland Patio Heater won't light, it could be due to a frosted propane cylinder; wait until the propane cylinder warms up and becomes unfrosted. Also, check for any blockage and clear it. Ensure that the control knob is turned to the ON position.
Why is the burner flame low on my Hiland Patio Heater?
The burner flame might be low on your Hiland Patio Heater due to several reasons. It could be that the gas pressure is low, in which case you should turn the cylinder valve off and replace the cylinder. If the outdoor temperature is less than 40ºF and the tank is less than 1/4 full, use a full cylinder. Also, check the burner and orifices for any blockage.
How to remove carbon build-up from Hiland Premium?
Carbon build-up on your Hiland Patio Heater is caused by dirt or film on the reflector and burner screen. Clean the reflector and burner screen to remove the carbon build-up.
How to fix uneven glow on Hiland Premium Patio Heater?
An excessively uneven glow on your Hiland Patio Heater is often caused by spiders and insects nesting in the burner or orifices. Clean the burner and orifices to restore even heating.
General| Type | Propane |
|---|---|
| Heat Output | 48, 000 BTU |
| Fuel Tank | 20 lb Propane Tank (not included) |
| Ignition | Piezo ignition |
| Material | Stainless Steel |
| Wheels | Yes |
Instructions for responding to a gas smell.
Risks of CO and mandate for outdoor use.
Dangers of improper installation or servicing.
Explains safety symbols and gas handling procedures.
Details risks of explosion, fire, and CO poisoning.
Attaching the wheel assembly to the bottom plate.
Connecting lower supports to the base and control box.
Fastening the control box and bottom plate with screws.
Fastening the top plate to the upper supports.
Installing the glass tube fixer and ceramic fiber.
Installing the AA battery for the igniter.
Attaching the upper supports to the lower frame.
Attaching the block belt to the lower supports.
Placing the glass tube and securing with the silicone ring.
