194412(11) - Hill-Rom® 900 Accella™ Bed - Instructions For Use Page 105
Regulatory Information
Changes and/or modifications not expressly approved by Hill-Rom Co., Inc. could
void the user's authority to operate the equipment.
The module must be installed and used in accordance with the Hill-Rom user and
installation instructions. Hill-Rom is not responsible for any radio or television
interference caused by unauthorized modification of the devices included with the
Hill-Rom module, or the substitution or attachment of connection cables and
equipment other than that specified by Hill-Rom Co., Inc. The correction of
interference caused by such unauthorized modification, substitution, or
attachment is the responsibility of the user. Hill-Rom is not liable for any damage
or violation of government regulations that may arise from the user failing to
comply with these requirements.
USA—Federal Communications Commission (FCC) Radiation
Exposure Statement
The radiated output power of the module is far below the FCC radio frequency
exposure limits. Nevertheless, the module must be used in such a manner that
the potential for human contact during normal operation is minimized. To avoid the
possibility to exceed the FCC radio frequency exposure limits, you should keep a
distance of at least 8" (20 cm) between you (or any other person in the vicinity)
and the antenna that is built into the wireless module.
Interference Statement for FCC
“Harmful Interference” is defined by the FCC as follows: Any emission, radiation,
or induction that endangers the functioning of a radio navigation service, or of
other safety services, or seriously degrades, obstructs, or repeatedly interrupts
a radio communications service, operating in accordance with FCC rules.
These devices comply with Part 15 of the FCC Rules. Operation of the devices is
subject to these two conditions: (1) the devices may not cause harmful
interference, and (2) the devices must accept any interference that may cause
unwanted operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
supply reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy. If the equipment is not installed and used in accordance with the
instructions, the equipment may cause harmful interference to radio
communications. There is no guarantee, however, that such interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception (which can be determined by turning the