Page 106 194412(11) - Hill-Rom® 900 Accella™ Bed - Instructions For Use
equipment off and on), the user is encouraged to take one of these measures to
try to correct the interference:
• Move this device.
• Increase the separation between the device and the receiver.
• Connect the device to an outlet on a circuit different from that of other
electronics.
• Consult the dealer or an experienced radio technician for help.
The module must be installed and used in strict accordance with the
manufacturer's instructions as described in the user documentation that comes
with the product. Any other installation or use will violate FCC Part 15
regulations. Modifications not expressly approved by Hill-Rom could void your
authority to operate the equipment.
The module must not be co-located or operated in conjunction with any other
antenna or transmitter.
Canada—Industry Canada (IC)
This device complies with RSS210 of Industry Canada.
Operation is subject to these two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, which include
interference that may cause unwanted operation of this device.
The term "IC" before the equipment certification number only signifies that the
Industry Canada technical specifications were met.
To prevent radio interference to the licensed service, this device is intended to be
operated indoors and away from windows to provide maximum shielding.
Equipment (or its transmit antenna) that is installed outdoors is subject to
licensing.
Caution—Exposure to Radio Frequency Radiation.
The installer of this radio equipment must make sure the antenna is located or
pointed such that it does not emit an RF field in excess of Health Canada limits for
the general population; consult Safety Code 6, obtainable from Health Canada's
website http://www.hc-sc.gc.ca/rpb.
Brazil
This product is embedded with the module WL18MODGI already homologated by
ANATEL with homologation code 07346-19-09891.
To Next Page