What to do if the spring element is not tensioned and the status indicator lights red on Hilti Tools?
If the spring element is not tensioned and the status indicator lights red on your Hilti Tools, there might be a system fault. In this case, remove the battery. Alternatively, ensure the battery is correctly inserted. Another possibility is that the magazine is empty, so you should load the magazine.
Why is the spring element not tensioned and there is no status indication on Hilti Tools?
If the spring element is not tensioned and there is no status indication on your Hilti Tools, it could be due to an empty battery. Try changing the battery. Another reason might be that the battery is not fitted correctly, so ensure that you insert the battery properly.
Why is the spring element not tensioned, the status indicator blinks green and 1 battery charge status LED blinks on Hilti Tools?
If the spring element is not tensioned and the status indicator blinks green while one battery charge status LED blinks on your Hilti Tools, it could be that the battery is empty, so you should change the battery. Also, the battery temperature might be too low. Allow the battery to warm up slowly to room temperature.
What to do if the fastener guide cannot be pressed in and the status indicator lights green on Hilti Tools?
If the fastener guide cannot be pressed in and the status indicator lights green on your Hilti Tools, a nail might be jammed in the fastener guide.
What to do if the spring element is not tensioned and the status indicator blinks red on Hilti Tools?
If the spring element is not tensioned and the status indicator blinks red on your Hilti Tools, the fastener guide may not be fitted correctly.
What to do if my Hilti BX 3-ME Power Tool spring element is not tensioned and the status indicator blinks green?
If the spring element isn't tensioned and the status indicator blinks green, it could be due to a depleted battery. Replacing the battery might solve the issue. Alternatively, the battery temperature might be too low. In this case, allow the battery to gradually warm up to room temperature.
Why is the spring element not tensioned on my Hilti BX 3-ME Power Tool?
The spring element might not be tensioned because the battery is empty. In this case, you should change the battery. Another possible cause is that the battery is not fitted correctly, so ensure the battery is properly inserted.
What to do if the spring element is not re-tensioned and the status indicator blinks green and 4 battery charge status LEDs blink on Hilti Tools?
If the spring element is not re-tensioned, the status indicator blinks green, and all 4 battery charge status LEDs blink on your Hilti Tools, the fastening tool may have overheated. Allow the fastening tool to cool down.
General| Weight | 3.5 kg |
|---|---|
| Battery capacity | 2.6 Ah |
| Magazine capacity | 30 fasteners |
| Width | 134 mm |
| Fastening speed | 1.3 fastenings per second |
| Fastener shank diameter | 3.0 mm |
| Base materials | Concrete, Steel, Masonry |
To Next Page
