*2231428*
2231428 English 11
7 Transport and storage of cordless tools and batteries
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery/batteries.
▶ Never transport batteries loose and unprotected. During transport, batteries should be protected from
excessive shock and vibration and isolated from any conductive materials or other batteries that may
come in contact with the terminals and cause a short circuit. Comply with the locally applicable
regulations for transporting batteries.
▶ Do not send batteries through the mail. Consult your shipper for instructions on how to ship undamaged
batteries.
▶ Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.1 Troubleshooting
Trouble or fault Possible cause Action to be taken
The drill / driver does not
work.
The battery is not correctly in-
serted.
▶ Insert the battery. → page 8
Battery is discharged. ▶ Change the battery and charge
the empty battery.
All 4 LEDs flash.
The drill / driver does not
work.
The drill / driver was overloaded
briefly.
▶ Release the control switch and
then press it again.
Protection against overheating ▶ Wait until the drill / driver cools
down and then clean the air
vents.
1 LED flashes.
The drill / driver does not
work.
Battery is discharged. ▶ Change the battery and charge
the empty battery.
The battery is too cold. ▶ Bring the battery to the recom-
mended working temperature.
The battery is too hot. ▶ Bring the battery to the recom-
mended working temperature.
SF 6H-A22
Hammer-action drilling is not
possible.
The operating mode is not set cor-
rectly at the selector ring.
▶
Set the selector ring to the
“Hammer-action drilling” posi-
tion .
To Next Page
Loading...
Need help?
General
