12 English
Note
Battery charge state cannot be displayed while the control switch is
pressed and for up to 5 seconds after releasing the control switch.
If the battery charge state LEDs blink, please refer to the information
given in the Troubleshooting section.
3.5 Indication of overloading and overheating
The power tool is equipped with an electronic system to protect against
overloading and overheating. The power tool switches itself off automatically
in the event of overloading or overheating. After releasing the control switch,
the power tool may not restart immediately when the switch is pressed again
(while the power tool is cooling down).
4 Technical data
4.1 Drill/driver
SF 6H-A22
Rated voltage
21.6 V
DC
Weight
4.4 lb
(2.0 kg)
Speed 1st
gear
0 /min …480 /min
2nd
gear
0 /min …1,600 /min
Torque (soft joint)
≤ 37 ftlb
f
(≤ 50 Nm)
Impact speed
28,800 /min
4.2 Accessory tools – permissible diameters
Ø keyless chuck diameter
range
1/16 in …1/2 in
Ø keyless chuck diameter
range
1.5 mm …13 mm
Ø wood drill bit (softwood)
1/16 in …3/4 in
Ø wood drill bit (softwood)
1.5 mm …20 mm
Ø wood drill bit (softwood)
1/16 in …1 1/4 in
Ø wood drill bit (softwood)
1.5 mm …32 mm
Ø Drill bits for metal
1/16 in …1/2 in
Ø Drill bits for metal
1.5 mm …13 mm
Printed: 01.02.2017 | Doc-Nr: PUB / 5329076 / 000 / 00