What to do if Hilti Drill insert tool can’t be released?
If the insert tool of your Hilti Drill can’t be released, it's likely that the chuck is not pulled back fully. Pull the chuck back as far as it will go and remove the tool.
What to do if Hilti Drill switches off automatically?
If the Hilti rotary hammer switches itself off automatically, the overload cut-out has likely been activated. Release the control switch, allow the rotary hammer to cool down, then press the control switch again, and reduce the load on the tool.
Why Hilti Drill control switch is locked?
If the control switch of your Hilti Drill can’t be pressed, and the switch is locked, the forward / reverse switch is likely in the middle position. Push the forward / reverse switch to the right or left.
What to do if Hilti Drill tool makes no progress?
If the Hilti Drill tool makes no progress, check that the rotary hammer has not been set to reverse rotation. If it has, move the forward / reverse switch to the “Forward” position. Also, ensure that the function switch is set to “Hammer drilling” and not “Drilling without hammering”.
What to do if Hilti Drill has no hammering action?
If your Hilti Drill has no hammering action, it could be because the rotary hammer is too cold. Bring the tip of the drill bit into contact with the working surface, switch the rotary hammer on and allow it to run. If necessary, repeat the procedure until the hammering mechanism begins to operate. Alternatively, the function switch might be set to “Drilling without hammering”. In this case, set the function switch to “Hammer drilling”.
What to do if Hilti Drill drive spindle does not rotate?
If the drive spindle of your Hilti Drill does not rotate, it could be due to several reasons. The permissible operating temperature of the rotary hammer’s electronics may have been exceeded, in which case you should allow the tool to cool down. Another reason could be that the battery is discharged, so you should change the battery and charge the empty battery. Finally, the function selector switch may not be correctly engaged or is set to “Chiseling”, or is set to “Chisel positioning”, so set the function selector switch to “Drilling without hammering” or “Hammer drilling”.
Why does my Hilti Drill battery run down quickly?
If the Hilti Drill battery runs down more quickly than usual, it might be due to a very low ambient temperature. Allow the battery to warm up slowly to room temperature.
What to do if Hilti Drill rotary hammer gets very hot?
If the Hilti rotary hammer drill or the battery gets very hot, immediately switch off the rotary hammer drill, remove the battery, and keep it under observation and allow it to cool down. The cause may be an electrical fault or the rotary hammer has been overloaded. If overloaded, use a more powerful tool.
What to do if the insert tool can’t be released from my Hilti Drill?
If the insert tool can’t be released from your Hilti Drill, ensure that the chuck is pulled back fully. Pull the chuck back as far as it will go and remove the tool.
General| Voltage | 36 V |
|---|---|
| Battery Capacity | 5.2 Ah |
| Battery Type | Li-ion |
| Optimum Hammering Range | 8 - 16 mm |
| Tool Holder Type | SDS-Plus |
| Chuck Type | SDS-Plus |
| Drilling Diameter (Steel) | 13 mm |
| Chiseling | Yes |
| Dust removal module available | Yes |
| Single Impact Energy | 3 J |
To Next Page
