Hilti TE 6-A36 - Technical Data; Operation

6 English 2100248
*2100248*
3.4 Items supplied
Rotary hammer, side handle, depth gauge, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4 Technical data
4.1 Rotary hammer
TE 6A36
Rated voltage
36 V
Weight
8.2 lb
(3.7 kg)
Rated speed under no load
1,050 /min
Single impact energy
2.5 J
Drilling diameter range in concrete/masonry (hammer drilling)
3/16 in … 1 1/16 in
Drilling diameter range in concrete/masonry (hammer drilling)
4 mm … 28 mm
Drilling diameter range in wood (solid)
1/8 in … 3/4 in
Drilling diameter range in wood (solid)
3 mm … 20 mm
Drilling diameter range in metal (solid-head drill bit)
1/8 in … 1/2 in
Drilling diameter range in metal (solid-head drill bit)
3 mm … 13 mm
5 Operation
5.1 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.2 Inserting the battery 2
CAUTION
Risk of injury! Inadvertent starting of the rotary hammer drill.
▶ Before installing the battery, check that the rotary hammer drill is switched off and that the forward/reverse
switch is in the middle position (i.e. switch-on interlock engaged).
1. Push the battery into the battery holder until it engages with an audible click.
2. Check that the battery is seated securely.
5.3 Removing the battery 3
1. Press the release buttons on the battery.
2. Pull the battery out toward the rear.
5.4 Fitting the side handle 4
CAUTION
Risk of injury! Loss of control over the product.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the clamping band is
engaged in the groove in the product.
1. Release the side handle clamping band by turning the handle grip.