HIMA HIMatrix F2 DO 16 02 - Configuring the Module with ELOP II Factory; Configuring the Outputs; Signals and Error Codes for the Output

4 Start-up F2 DO 16 02
Page 30 of 42 HI 800 139 E Rev. 2.00
4.4 Configuring the Module with ELOP II Factory
4.4.1 Configuring the Outputs
The signals previously defined in the Signal Editor (Hardware Management) are assigned to the
individual channels (outputs) using ELOP II Factory. Refer to the system manual for compact
systems or the online help for more details.
The following chapter describes the system signals used for assigning signals in the remote I/O.
4.4.2 Signals and Error Codes for the Output
The following tables specify the system signals that can be read and set for the outputs,
including the corresponding error codes.
In the user program, the error codes can be read using the signals assigned within the logic.
The error codes can also be displayed in ELOP II Factory.