HIMA HIMatrix F2 DO 16 02 - Decommissioning

42 pages

To Next Page

To Previous Page

7 Decommissioning F2 DO 16 02

Page 34 of 42 HI 800 139 E Rev. 2.00

7 Decommissioning

Remove the supply voltage to decommission the device. Afterwards pull out the pluggable

screw terminal connector blocks for inputs and outputs and the Ethernet cables.

Main Page

Certified Himatrix F22
Table of Contents F22
Table of Contents3
Introduction5
Structure and Use of this Manual5
Table 1: Programming Tools for Himatrix Remote I/Os5
Target Audience6
Formatting Conventions7
Safety Notes7
Operating Tips8
Safety9
Intended Use9
Environmental Requirements9
ESD Protective Measures9
Table 3: Environmental Requirements9
Residual Risk10
Safety Precautions10
Emergency Information10
Product Description11
Safety Function11
Equipment, Scope of Delivery12
IP Address and System ID (SRS)12
Type Label13
Figure 1: Sample Type Label13
Structure14
Figure 2: Front View14
Figure 3: Block Diagram14
Safety-Related Relay Outputs15
Burner Control Applications15
General Safety Applications16
Figure 4: Contact Lifetime AC16
LED Indicators17
Operating Voltage LED17
System Leds17
Table 5: Operating Voltage LED17
Table 6: System Leds17
Communication Leds18
I/O Leds18
Table 7: Ethernet Indicators18
Table 8: I/O Leds18
Communication19
Connections for Ethernet Communication19
Network Ports Used for Ethernet Communication19
Figure 5: Sample MAC Address Label19
Table 9: Ethernet Interfaces Properties19
Table 10: Network Ports in Use19
Reset Key20
Product Data21
Table 11: Product Data21
Table 12: Specifications for the Relay Outputs22
Table 13: Relays Output Switching Capacity22
Table 14: Certificates23
Start-Up24
Installation and Mounting24
Connecting the Digital Outputs24
Cable Plugs25
Table 15: Terminal Assignment for the Relay Outputs25
Table 16: Power Supply Cable Plug Properties25
Table 17: Input and Output Cable Plug Properties25
Mounting the F2 DO 16 02 in Zone 226
Figure 6: Label for Ex Conditions26
Configuration27
Configuring the Remote I/O with Silworx27
Parameters and Error Codes for the Output27
Digital Outputs for F2 DO 16 0227
Tab Module28
Table 18: Silworx - System Parameters for Digital Outputs, Module Tab28
Tab DO 16: Channels29
Table 19: Silworx - System Parameters for Digital Outputs, DO 16: Channels Tab29
Configuring the Module with ELOP II Factory30
Configuring the Outputs30
Signals and Error Codes for the Output30
Digital Outputs for F2 DO 16 0231
Table 20: ELOP II Factory - Digital Output System Signals31
Operation32
Handling32
Diagnosis32
Maintenance33
Faults33
Maintenance Measures33
Loading the Operating System33
Proof Test33
Decommissioning34
Transport35
Disposal36
Appendix37
Glossary37
Index of Figures38
Index of Tables39
Index40

HIMA HIMatrix F2 DO 16 02 - Decommissioning

Table of Contents