(APPENDIX IV) DIMENSIONS, WIRING AND MECHANICAL PARTS | PAGE 61
13.3 SYMBOLS
Warning. Consult the manufacturer's documentation.
Consult the manufacturer's documentation.
Risk of electric shock.
Class II device. Equipment protected with double isolation or reinforced
isolation.
Equipment included in Directive 2012/19/EU on waste electrical and
electronic equipment (WEEE).This equipment must be disposed of sep-
arately from normal waste; it must be left at an electrical and electronic
equipment collection and recycling point.
Direct current.
13.4 GENERAL INFORMATION, CHARACTERISTICS AND INSTALLATION OF THE
EQUIPMENT
The following documentation is supplied with the equipment:
1. General information:
It is necessary to consult the documentation.
2. Characteristics:
The equipment has been designed to be safe in the following range of environ-
mental conditions:
• The control units must be mounted inside an electrical panel, which is
used outdoors.
• Operating temperature -20°C ~ +60°C.
• Maximum relative humidity 80% (without condensation).
3. Installation:
The equipment is included within the measurement category CAT III 600 V for
measurements performed in the building installation.
Disconnection means should be incorporated to the xed installation in accord-
ance with installation regulations. Such means must have contact separation for
all poles that provide full disconnection in category III overvoltage conditions.
The disconnecting means must be accessible by the user. The surface areas of
the equipment and the external face should be cleaned with a damp cloth.
The manufacturer is not liable for any damage caused by not following the warn-
ings and / or recommendations indicated in the manual, since the protection
ensured by the equipment may be compromised.
To Next Page
Loading...
Need help?
General
