24
Guidance and manufacture’s declaration – electromagnetic immunity
The ABP-03 is intended for use in the electromagnetic environment specified below. The
customer or the user of the ABP-03 should assure that it is used in such an environment.
Portable and mobile RF communications
equipment should be used no closer to any part of
the ABP-03, including cables, than the
recommended separation distance calculated
from the equation applicable to the frequency of
the transmitter.
Recommended separation distance
Where P is the maximum output power rating of
the transmitter in watts (W) according to the
transmitter manufacturer and d is the
recommended separation distance in metres (m).
Field strengths from fixed RF transmitters, as
determined by an electromagnetic site survey,
a
should be less than the compliance level in each
frequency range.
b
Interference may occur in the vicinity of equipment
marked with the following symbol:
IEC
61000-4-3
3 V/m
80 MHz to 2.5
GHz
3 V/m
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected
by absorption and reflection from structures, objects and people.
and land
mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted
theoretically
with accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an
electromagnetic site
To Next Page
Loading...
