Hioki 3802-50 - Pulse Width Measurement

29
Chapter 6 Summary of SCPI Commands
Command Parameter Description
SOURce?
Query the plus output function. (Only 3801-50)
SQUare
Set the puls output. (Only 3801-50)
:DCYCle:DECimal <numeric>: 1 to 255
Set the duty ratio of the pulse output.
:PWIDth:DECimal <numeric>: 1 to 255
Set the pulse width of the pulse output .
:FREQuency <numeric>
Set the frequency of the pulse output .
SYSTem
:AOFF:TIME <minute>: 0 to 99
Set the time of the auto power save function.
:BEEPer [<CONT|STOP|TONE>]
Set the action of the beeper
:BLIT <Boolean>
Enable or disable the back lit.
:TIME <second>: 0 to 99
Set the time of the back lit.
:CPERcent < 0-20 | 4-20 > For DCmA measurements, select the % conversion.
:TCOMpensated <Boolean>
Sets 0 ℃ temperature compensation.
:TENVironment <Boolean>
Selects display of environment (ambient)
temperature.
:DEFAult
Returns meter settings to their factory defaults.
:BATTery?
Queries the remaining charge state of the
battery.
:ERRor?
Query the error message.
:VERSion?
Query the version of the SCPI.
STATus?
Query the status of the meter.