Chapter 5 Instructions of Command Sets
24
SYSTem Subsystem:
SYSTem:ERRor?
SYSTem:VERSion?
SYSTem:BEEPer [< CONTinous | STOP | TONE >]
SYSTem:TCOMpensated <Boolean>
SYSTem:TENVironment <Boolean>
Description Query the error message.
Response Return <Number,"Error String"> format string. The following
table is a list of SCPI error message that might occur during
operation.
The buffer size of the system error queue is one.
SCPI Error Message
Num
ber
Error String
Num
ber
Error String
+0
No error
-213
Init ignoredInit
-100
Command error
-220
Parameter error
-200
Execution error
-230
Data stale
Description Query the version of the SCPI.
Response Return 1999.0 string.
Description • Set the action of the beeper.
• Ignore the original state of the beeper.
Parameter If parameter is omitted, the meter is set to tone.
CONT- beep continuously.
STOP- stop to beep.
TONE- beep one tone.
Example
SYST:BEEP:beep one tone.
Description Enable or disable the "0°C" temperature compensation.
The function switch is at
C measurement
.
Set this after enabling temperature measurement with the
TEMP command .
❖ 17p
Parameter Value to be entered to <Boolean>: ON, 1: OFF, 0
Description Select whether to display the environment (ambient)
temperature on the sub display (measured by an internal
thermal sensor). This selection is available when not
measuring on the sub display.
Parameter Value to be entered to <Boolean>: ON, 1: OFF, 0
To Next Page
Loading...
