Hioki Analog MO HiTESTER Series User Manual

Chapter 1 Overview
12
Carrying case inside structure
1.2 Using a Carrying Case
Undo the snap fastener on OPEN
mark side. Lift the cover and pivot it
to the side and under the case itself
and redo the snap fastener on the
side of the cover.
Fasten the strap as shown below. You can use the instrument
hanging around your neck.
1. Undo the snap fastener for the stra
on the left side of the case.
2. Undo the snap fastener for the stra
on the right side of the case an
redo it as shown in the right figure.
1.
2.
Instruction
manual
Alligator clip
Pocket
Removable sleeves are attached to the metal pins at the ends of
the test leads.
To prevent a short circuit accident, be sure to use the test leads
with the
sleeve s attached when performing measurements in the
CAT III measurement category. Remove the sleeve s from the test
leads when performing measurements in the CAT I and CAT II
measurement categories. The secondary side of a breaker which
is set to OFF is CAT I. For details on measurement categorie, see
Measurement categories(  p.6) in the instruction manual. When
performing measurements with the
sleeve s attached, be careful to
avoid damaging the sleeve s. If the sleeve s are inadvertently
removed during measurement, be especially careful in handling
the test leads to avoid electric shock.

Hioki Analog MO HiTESTER Series Specifications

General

Brand	Hioki
Model	Analog MO HiTESTER Series
Category	Test Equipment
Language	English