Instrument Installation
To avoid damage to the instruments and potentially life-
threatening hazards, observe the following precautions.
• Use only the specified/supplied Model Z1004 AC Adapter.
AC adapter input voltage range is 100 to 240 VAC (with
±10% stability) at 50/60 Hz. To avoid electrical hazards
and damage to the instrument, do not apply voltage out-
side of this range.
• Before turning the instrument on, make sure the supply
voltage matches that indicated on the AC adapter. Con-
nection to an improper supply voltage may damage the
instrument or AC adapter and present an electrical haz-
ard.
• If the protective functions of the instrument are damaged, either
remove it from service or mark it clearly so that others do not
use it inadvertently.
• To avoid damage to the instrument, protect it from physical
shock when transporting and handling. Be especially careful
to avoid physical shock from dropping.
• To avoid breaking the cables, do not bend or pull them.
• For safety reasons, when taking measurements, only use the
L9094 Output Cord provided with the instrument (FT3406
only).
To Next Page
Loading...
Need help?
General
