Chapter 4 Instrument Functionality
The system is reset when turning on the system.
Turn on the instrument by pressing the
[POWER] key while hold-
ing down the
[CLR] key to reset the system.
Reset parameters
The instrument’s remaining battery life is
shown at the top right corner of the display.
Resetting the System
Measured value Cleared
Maximum and minimum values Cleared
Measurement function Rotational speed measurement
Measurement unit r/min
Auto Power Save function ON
Averaging function OFF
Buzzer ON
Output function Aout×10
Battery Warning (Remaining Battery Life Detection)
Remaining battery
life indicator
Battery status
After new alkaline batteries have been loaded
When 2/3 of the battery life remains
When 1/3 of the battery life remains
(Flashing) There is no battery life remaining. When
this indicator is displayed, further measurement is
not possible. Replace the batteries in the instrument.
• Use of manganese batteries will result in a dra-
matically shorter continuous operating time.
• The remaining battery life indicator will not oper-
ate properly when using nickel-metal-hydride
batteries.