Chapter 2 Preparing for Measurement
索引
4
3
2
1
7
6
5
10
9
8
Connecting the AC Adapter (Option)
(FT3406 only)
Use only the specified Model Z1004 AC Adapter. AC
adapter input voltage range is 100 to 240 VAC (with
±10% stability) at 50/60 Hz. To avoid electrical hazards
and damage to the instrument, do not apply voltage out-
side of this range.
• AC adapter output may decrease due to power
supply noise, a momentary loss of power, or
other factors. To keep the instrument operation
from stopping due to these effects when acquir-
ing data for an extended period, it is recom-
mended to use alkaline batteries in the device,
even when operating on AC adapter power.
• Make sure the power is turned off before con-
necting or disconnecting the AC adapter.
• The AC adapter has priority when connected.
Consequently, power is not drawn from batteries
when the instrument is operating using power
supplied from the AC adapter.
• The indicator is not displayed when no
power is being supplied to the AC adapter or
when there is a power outage (at this time, the
instrument will operate using battery power).
1.
Turn off the instrument.
2.
Remove the cap on the bottom of the grip
and insert the AC adapter jack into the
connector.
3.
Connect the AC adapter plug to the
power supply.
4.
Turn on the instrument.
5.
The indicator will be shown on the
instrument’s display while power is being
supplied.
To Next Page
Loading...
Need help?
General
