Hioki LR8450 - Page 105

101
Troubleshooting
No. Message Solutions
WARN_WLAN01 This wireless unit has already been added
to the registration list.
Check the list of the modules to be
registered.
See “1.2 Registering Wireless Modules”
in the Instruction Manual.
WARN_WLAN02 Maximum number of units that can be
registered has been exceeded.
You can register up to seven wireless
modules.
Deregister the unwanted wireless
modules.
WARN_WLAN03 Searching for a new wireless unit failed.
See [Action during communication error] in
QUICK SET.
See [Action during communication
error] in the conguration navigation.
See “1.15 Conguration Navigator
(QUICK SET)” in the Instruction Manual.
WARN_WLAN04 Some wireless units have failed to register. See [Action during communication
error] in the conguration navigation.
WARN_WLAN05 Failed to re-initialize wireless LAN. See [Action during communication
error] in the conguration navigation.
WARN_WLAN06 Some wireless units have failed to
reconnect.
See [Action during communication
error] in the conguration navigation.
WARN_WLAN07 When setting security, set the password to
at least 8 characters.
When communicating data through the
wireless LAN after encryption, set a
password with at least eight characters.
See “9.4 Using the Wireless Modules
(LR8450-01 only)” in the Instruction
Manual.
WARN_WLAN08 Invalid IP address has been entered. Check the following points:
• Is the IP address the same as that of the
wireless LAN?
• Is the address the same as the subnet
mask?
• Is the broadband address mistakenly
entered?
WARN_WLAN09 The communication environment cannot be
inspected because the wireless LAN setting
is turned OFF.
Set the wireless LAN mode to ON.
WARN_
WLAN010
New wireless unit not found.
The wireless interface of the instrument may
be busy. Please try again.
Search for wireless modules again.
If not remedied, see [Action during
communication error] in the
conguration navigation.
See “1.15 Conguration Navigator
(QUICK SET)” in the Instruction Manual.
WARN_
WLAN011
This wireless unit is not connected
to the instrument. See [Action during
communication error] in QUICK SET.
See [Action during communication
error] in the conguration navigation.
See "1.15 Conguration Navigator (Quick
Set)" in the Instruction Manual.
MSG_SU07 Settings for recording interval has been
optimized. (Recording time, le division
time, pre-trigger, horizontal axis, etc.)
Check the following settings, which may
have changed:
• [Recording interval]
• [Split time] under [File splitting]
• [Pre-trigger]
• [Horizontal axis] (time per division)
• Measurement module data update
interval (changed to optimal interval
during auto operation)
• [Split time] in [Time split calculation]
under [Numerical calculation]
Maintenance and Service
HIOKI LR8450A963-02