48
Installation BRS20/30/40/50
Release
02
11/2018
2.6 Connecting data cables
Note the following general recommendations for data cable connections in
environments with high electrical interference levels:
Keep the length of the data cables as short as possible.
Use optical data cables for the data transmission between the buildings.
When using copper cables, provide a sufficient separation between the
power supply cables and the data cables. Ideally, install the cables in
separate cable channels.
Verify that power supply cables and data cables do not run parallel over
longer distances. If reducing the inductive coupling is necessary, verify
that the power supply cables and data cables cross at a 90° angle.
Use shielded cables.
Connect the data cables according to your requirements.
See “Ethernet ports” on page 31.
2.7 Filling out the inscription label
The information field for the IP address helps you identify your device.
2.8 Making basic settings
Note: Two or more devices configured with the same IP address can cause
unpredictable operation of your network.
Install and maintain a process that assigns a unique IP address to every
device in the network.
The IP parameters must be entered when the device is installed for the first
time. The device provides the following options for configuring IP addresses:
Entry via the HiDiscovery protocol in the applications HiDiscovery or
Industrial HiVision
Configuration via BOOTP
Configuration via DHCP (Option 82)
AutoConfiguration AdapterACA22-USB-C (EEC)
Configuration via USB-C interface
To Next Page
Loading...
Need help?
General
