Hirschmann EAGLE 20 - Page 26

Using the CLI
26
3.1 Mode-based command hierarchy
RM CLI EAGLE 20
Release 4.3 09/08
Figure 10: Commands in the Global Configuration mode
Note: You will find information on the line feed of the help texts below (see
on page 35 „Line length“).
*(Hirschmann Eagle) #configure
*(Hirschmann Eagle) (config)#?
authentication Configure an authentication list.
denial-of-service Configure denial of service (flood protection)
parameters.
device-status Configure the device status settings.
dhcp-relay Modify DHCP Relay parameters.
dhcp-server Modify DHCP Server parameters.
exit Exit from current mode.
help Display help for various special keys.
history Show a list of previously run commands.
interface Configure the interface parameters.
lldp Configure the LLDP settings.
logging Logging configuration.
nat Configure the NAT settings.
packet-filter Configure the packet-filter.
ping Send ICMP echo packets to a specified IP address.
redundancy Configure the redundancy settings.
save Save configuration.
show Display device options and settings.
signal-contact Configure the Signal Contact settings.
snmptrap Configure SNMPv3 traps.
sntp Configure SNTP settings.
temperature Configure the temperature limits.
user-firewall Configure the user firewall settings.
users Manage Users and User Accounts.
vpn Configure VPN settings.