Example
38
3.3
Properties of the CLI
RM CLI EAGLE 20
Release
4.3
09/08
The “login” command is used to perform this task.
Enter “login”.
“lo” and a space character is not sufficient here, as it is not clear wheth-
er you want to execute the “login” or “logout” command. However, if
you enter a space again, you get a list of the commands that begin with
“lo”.
Finding, completing and executing commands
After “login” enter a question mark to display the additional branches
of the command.
The “login timeout” command is used to perform this task.
After “login”, enter a “t” and a space. The CLI automatically completes
the command to “login timeout” .
After “login timeout” enter a question mark to display the additional
branches of the command.
The “login timeout ssh” command is used to perform this task.
After “login timeout ssh” enter a question mark to display the possible
parameters for the command.
!(Hirschmann Eagle) #lo
login Set login parameters.
logout Exit this session. Any unsaved changes are lost.
!(Hirschmann Eagle) #login ?
access Set login access parameters.
timeout Set login timeout parameters.
!(Hirschmann Eagle) #login timeout ?
serial Set login timeout for serial line connections.
ssh Set login timeout for SSH connections.
web Set login timeout for web connections.
To Next Page
Loading...
